One does not necessarily require the knowledge of an engineer for the design of a turntable. All that is required is you having a basic understanding of most of the components of the turntable. In addition, you can have some understanding of how they work, owing to the fact that they will pop up the most time in discussions. In summary, the objective of the turntable is to put a needle on a record just so that it can produce some form of music. You can most definitely find more information on this subject on the Pickmyturntable official website.

Below are some of the main components that go into the recreation of the sound that is contained on the record.

Plinth (Base) – This is the foundation of the turntable as it is responsible for the support of the components of the turntable. The base, which is also referred to as the Plinth has some feet attached to it in order to guarantee its stability, which ensures great playback. The base can be fabricated from various materials including metal, plastic or wood.

Platter – This is the component rotating on which the record spins/rests. The heavier the plater, the better, in the sense that it results in fewer vibrations. It is without a doubt that the motor powers it and it has some form of a mat that is placed in between the record and the surface. The mat helps in the provision of a cushion for the record. In addition, it held with dampening vibration and its grip.

The Motor–The motor part of the turntable has fan, both the direct drive and belt drive design. There is so little significant between the sounds these two motor can create but the thing is in the belt drive design turntable motor it is separated from its platter, which is rotated via its belt while the direct drive has a built-in motor turntable. Even though there are open arguments over which of the two motor types reigns best, the choices preferences does not pertain to it since both are just excellent on their own but most DJ and DJ aspirant wanted the direct drive motor turntable since it is faster to spin and has high torque compared to the belt type motor.

The Tonearm– Though it is a dubiously delicate component of the turntable the beauty is that it is where the cartridge lays and created to assist the job of the cartridge in tracking down the record conveniently as possible. Its dense should allow adequate balance for the cartridge to play, with different cartridges types and designs such as the straight or the s-tonearm, it is important that it won’t push it or exhaust the spin. There is nothing so different on the outer design or beauty for tonearms, but many prefer the one with short and straight for better scratch. However, it is not recommended for ordinary players since it types also have more chances to wear down or damage the record.

The Cartridge Of The Turntable–Many makers of turntable allows buying the record players from third party companies for cartridges but altogether, the design of the cartridge is a different technology with the turntable itself. It usually comes with magnet and coil and at the minimum level, the cartridge should make an electric impulse as it reacts with the stimuli that move on the surface. The wave of the sound uses the pre-amplifier to optimized the sound and goes to the speaker to be heard.

The Phono Stage–A turntable is just nothing when there is no electricity that flows on it for you to hear the sound, and for that you need the phono pre-amplifier or the phono stage that is why it is better for you to get the good external phono stage since it will is capable to create bigger image performance but there are turntables that have the phono stage already built-in it. But in case you need to have a phono stage, you should pick the one that external phono stage as it can better feed the sound system to create a nicer signal on the audio. The output of the sound should be crispier and accurate so that it is pleasurable in the ear.

You have just learned the different component parts of the turntable. The simplicity of its parts together with the function is just an easy task to understand, some teen can even play turntables and comprehend the work of its parts just like a pro so you do not have to fret over it much.